Readjustment Is Out Of Range; Pro-Match/Minimisation Was Carried Out Incorrectly; Wheel Slips On The Wheel Adapter - Hofmann geodyna 2600 Operation Manual

88
89
90
91
E9 - Fig. 88

Pro-Match/minimisation was carried out incorrectly.

1. Wheel was not exactly centered on the wheel adapter
during every run.
2. Tire was mounted eccentrically on the rim for at least one
time.
3. Valve position was incorrectly indexed for at least one
time, and entered incorrectly.
4. Wrong mark (single or double mark) was used for refer-
ence when readjusting the tire.
5. Wheel got out of place on the wheel adapter during the
measuring run.
6. Wrong wheel dimensions were entered.
• Repeat the Pro-Match procedure.
E15 - Fig. 89

Readjustment is out of range.

During readjustment values were determined which exceed, or
fall below, the adjustment value.
• Press the CODE key to transfer the corrective terms
into the permanent memory.
• Call for the service technician to readjust the machine.
E16 - Fig. 90
During the first readjustment run by the operator the calibra-
tion weight was attached by mistake.
• Unscrew the calibration weight and start the measuring
run again.
E17 - Fig. 91

Wheel slips on the wheel adapter.

The clamping nut is not tight, the main shaft accelerates too
quickly. The machine will stop.
• Firmly tighten the clamping nut, or if the wheel is very
small press the START key a little bit longer.
Operation manual geodyna 2600 EEWB703D
Error codes
41