View Wheel Balancer; General Safety Rules; Front View - Hofmann geodyna 2600 Operation Manual

3
2
1
2600 2800
6
1
Fig. 1 View wheel balancer

Front view

1 Weight tray
2 Display and key pad
3 Wheel guard
4 Gauge arm for distance rim/machine and rim diameter
5 Pedal for main shaft lock
6 Rear view

1.3 General safety rules

4
Only properly trained and authorised personnel shall be al-
lowed to operate the wheel balancer.
The machine must not be used except for the scope of ap-
plication and in the way specified in this manual.
Unauthorized changes and modifications to the machine
relieve the manufacturer from any liability for damages and
injuries that might result therefrom.
On no account should safety features be removed or made
inoperative.
5
In general any work on the electrical system such as fitting of
a plug or changing of connections, if necessary, must be car-
ried out by a qualified electrician in line with relevant national
standards and the regulations of the local power station.
It should be noted that working with technical equipment may
involve an unforeseeable acceptable risk.
Therefore the operator should eliminate such dangers in
advance by proper and wise behavior.
The following special points should be observed:
Use technical equipment for its specified scope of application
only.
Always use suitable and proper equipment and tools.
Follow the instructions, notes and technical data of the
machine manufacturer or manufacturer of the wheels to be
balanced.
Wear suitable protective clothing and accessories (e. g.
goggles, safety shoes, helmet).
For further safety rules to be observed, please refer to the
individual chapters.
Operation manual geodyna 2600 EEWB703D
Safety rules and function
3