Code C3; Code C4; Code C5 - Hofmann geodyna 2600 Operation Manual

Input: Code/state
68
-
to 4
Compensation run completed
After the mesuring run
-
to 0
69
-
to 5
-
to 0
-
to 1
70
Display: Code/state
C 4 0
C 4
1
C 4 0
C 5
C 5 0
C 5
1
Changing modes of operation

Code C3

Fig. 68 Selecting unbalance readings in grammes or ounces,
active when the machine is switched on
0 = Readings in grammes 1*
= Readings in ounces
The selected mode of operation can be transferred to the
permanent memory.

Code C4

Fig. 69 Electrical compensation of residual unbalance in the
wheel adapter
Measurement with increased precision (this mode cannot be
transferred into the permanent memory).
Compensation has to be cancelled and carried out once again
when the wheel adapter is exchanged.
Resetting the status to 0 cancels the compensation of adapter
unbalance.
The compensation is cancelled by calibration, or readjustment
of the machine, by Pro-Match, or when the machine is turned
off.
0 = Carry out compensation
1 = Compensation completed
0 = Compensation after the measuring run switched off
again

Code C5

Fig. 70 Braking of the wheel when the (optional) wheel guard
is opened during the measuring run
If the mode is set to "0", the wheel rotates when the wheel
guard (option) is open.
Caution! Rotating wheel may swing away objects
and draw in clothes.
Injuries are possible.
• Wear safety goggles and tightly fitting working clothes.
• Make sure that the wheel is not blocked by tools or the like.
0 = No braking
1* = Braking
The selected mode of operation can be transferred to the
permanent memory. * =
Factory adjusted mode
Operation manual geodyna 2600 EEWB703D
35