Display Panel - Section On The Right; Pedal Of Main Shaft Lock - Hofmann geodyna 2600 Operation Manual

Controls and displays
inch mm
1
START
8
15
16
12
2 3 4 5
6
7
Fig. 15 Display panel - section on the right
1 Loudspeaker symbol
2 inch/mm
The unit of measurement (inch or mm) is chosen by using
the rim diameter key.
3 Rim diameter
lights whenever rim diameter key is pressed.
4 Digital display of right correction plane to show:
- rim diameter
- distance rim/machine (always in mm)
- amount of unbalance of right correction plane
- state of modes of operation or preset limit values
5 Direction indicator of right correction plane
6 Indicates when correction position in the right
correction plane has been reached.
7 Distance machine/left correction plane
lights whenever distance key is pressed or gauge arm for
distance and rim diameter is moved.
8 START
flashes when the START key is to be pressed during pro
match and operator calibration.
Fig. 16 Pedal of main shaft lock
The main shaft is locked when the pedal is depressed. This
will facilitate tightening or untightening of the clamping nut, as
well as retaining the wheel in correction position for correct
fitting of the balance weights.
This lock is designed only to facilitate orientation of the wheel
and must not be used for braking the main shaft.
Operation manual geodyna 2600 EEWB703D