Readjustment Of The Machine By The Operator; Store Wheel Profile; Select Previously Stored Wheel Profile - Hofmann geodyna 2600 Operation Manual

Changing modes of operation
Input: Code/state
- +
to 3
77
- +
to 3
78
38
Display: Code/state
RCL 1
RCL 3
STO 1
STO 3
Code C14

Readjustment of the machine by the operator

See § 13. User calibration.
Code C17
Fig. 77 Select previously stored wheel profile
Load a previously stored wheel profile. This replaces the
previously valid settings.
• Keep the OPERATOR key pressed on bottom. RCL
(recall) comes up in the left-hand section of the display
and 1 comes up in the right-hand section for the first
wheel profile to be loaded.
• Keep the key pressed on bottom and rotate the wheel.
Profiles 2 through 4 are read out in the right-hand
display. The stored wheel profile (e. g. 3) is entered
once the key is released.
The following information is available (if applicable):
- Nominal wheel dimensions
- Values measured with the gauge arm
- Weight positions
- Positions for relocation See also C18
Code C18
Fig. 78 Store wheel profile
• If a wheel profile is to be stored, keep on pressing the
OPERATOR key after the RCL readings have come
up and continue rotating the wheel. Now STO (store)
comes up in the left-hand display, and No. 1 through
4 can be set in the right-hand display by rotating the
wheel. The current profile is stored once the key is
released.
It is possible to store up to 4 wheel profiles.
The following values (if available) are stored:
- Nominal wheel dimensions
- Values measured with the gauge arm
- Weight positions
- Positions for relocation
See also C17
Operation manual geodyna 2600 EEWB703D