Hofmann geodyna 2600 Operation Manual page 9

11b
Fig. 11b Function keys on the right
11 FINE/INT
FINE (pressed on top):
- Show amount reading with higher resolution:
1 gramme instead of 5 grammes or 0.05 oz instead of
0.25 oz (only for as long as the key is pressed)
- Display residual wheel unbalance below the threshold for
suppression of minor unbalance readings: As long as
the key is pressed the suppression of minor unbalance
11
readings is switched off and the actual unbalance in the
wheel is read out.
- Display unbalance for standard balancing mode: if bal-
ancing mode Alu 1 to Alu 5 is selected, press and hold
the FINE key and then press the function key for balanc-
ing mode (ALU, ALU+). The unbalance readings switch
over to those for standard balancing mode and the rela-
tive rim symbol appears.
- In the OP and Un programs the FINE key serves as
change-over key.
INT (pressed on bottom):
Switches to the patch balance mode. All wheel data
must have been entered. In addition the height-to-width
ratio specified on the tire has to be entered by pressing
the diameter key and rotating the wheel.
Readout display changes to single-plane. Both loca-
tion displays are active and work in parallel. Distance
and diameter dimensions have no effect and are preset
to nominal values. All special functions are inactive and
cannot be selected.
Operation manual geodyna 2600 EEWB703D
Controls and displays
9