Changing Modes Of Operation; If The Desired State Is Already Read Out; If The Desired State Has To Be Set - Hofmann geodyna 2600 Operation Manual

- +
to 2
- +
to 1
Code
63
64
C 2 0
C 2 1
State

Changing modes of operation

10. Changing modes of operation
Inputs and readings when a mode of operation is changed
(Fig. 63 - example code C2)
• Press and hold the CODE key. The
C code that was last set is displayed.
• Rotate the wheel to set the desired code (e. g. 2) in the
display.
• Release the CODE key when the desired code is read
out.
C and code number 2 are read out in the left digital display.
The right digital display shows the present state of this code,
e. g. 0 for switched off.

If the desired state is already read out:

• Press the CODE key to return to the basic reading (Fig.
64), or abort by pressing STOP.

If the desired state has to be set:

• Press and hold the FINE key.
Rotate the wheel to set the desired state (e. g. 1) in the
display. For some codes a given value can be set.
• Release the FINE key when the desired code or value is
read out.
• Press the CODE key to acknowledge the input and to
return to the basic reading (Fig. 64), or abort by press-
ing STOP.
Quit the C code or abort and return to normal working mode:
• Press the STOP key.
Having completed the input of mode of operation it will remain
stored until the machine is switched off with the main switch,
or until a new input is made.
The changed modes can also be stored permanently with
code C10, so that they are not cancelled when the machine is
switched off but are retained in a permanent memory for future
use until a new input is made and stored. Code C4 Compen-
sation of clamping means cannot be stored in the permanent
memory.
The possible changes of codes and the necessary inputs are
described in the following.
Operation manual geodyna 2600 EEWB703D
33