Input For Display Of Static Unbalance; Store Wheel Profiles; Correction Of Inputs After Measurement - Hofmann geodyna 2600 Operation Manual

Entry of balancing mode and wheel size
26

7.2.7 Input for display of static unbalance

For wheels which should only be balanced statically, only the
correction diameter has to be entered.
Input is made as for standard wheels.
• Press and hold the diameter key and rotate the wheel to
set the diameter values.
• Release the key as soon as the desired value is read
out.

7.2.8 Store wheel profiles

Wheel profiles permit the storage of values for wheels that
are balanced frequently so that the wheel data need not be
entered again and again. This function is particularly useful for
shops that frequently handle the same wheel types.
It is possible to store up to 4 wheel profiles via code C18 and
to select previously stored profiles via code C17 (see § 10.
Changing modes of operation).
The following values are stored:
- Wheel dimensions
- Values measured with the gauge arm
- Weight positions
- Positions for relocation
• Press and hold OPERATOR key (on bottom).
RCL comes up in the left-hand section of the display
and 1 comes up in the right-hand section for the first
wheel profile to be stored. Keep the key pressed on
bottom and rotate the wheel. Profiles 2 through 4 are
read out in the right-hand display. The stored wheel
profile is entered once the key is released. If a wheel
profile is to be stored, keep on pressing the key after
the RCL readings have come up and continue rotating
the wheel. Now STO (store) comes up in the left-hand
display, and No. 1 through 4 can be set in the right-hand
display by rotating the wheel. The current profile is
stored once the key is released.

7.2.9 Correction of inputs after measurement

Upon operation of the FINE key the electronic unit accepts the
new input, processes it and then reads out the corrected
measured data without need to repeat the measuring run.
Operation manual geodyna 2600 EEWB703D