Preparation For Installation; Servo Drive - Danfoss VLT Integrated Servo Drive ISD 510 System Operating Instructions Manual

Mechanical Installation

4.4 Preparation for Installation

4.4.1 Servo Drive

Make the following preparations to ensure that the
ISD 510 servo system can be installed reliably and
effectively.
4 4
1. Provide a suitable mounting arrangement for the
application. This depends on the type, weight,
and torque of the servo drives.
2. Seat the motor flange flush against the mounting
surface before fixing the servo drive.
Misalignment shortens the life of the bearing and
the coupling components and reduces heat
transfer from the servo drive.
3. Provide contact protection according to local
regulations if hot surfaces can be expected
during operation.
4. Ground the servo drive as described in
chapter 5.4 Grounding.
Always fit couplings and other transfer components in
accordance with local regulations.
30
®
VLT Integrated Servo Drive ISD
Danfoss A/S © 12/2015 All rights reserved.
®
510 System
MG75K102