Danfoss VLT Integrated Servo Drive ISD 510 System Operating Instructions Manual page 44

Electrical Installation
Connecting the LCP cable
1. Align the connector on the cable with the LCP
connector marked X5 on the servo drive.
2. Press the connector towards the electronic
housing of the servo drive and tighten the
threaded ring of the connector by turning it
clockwise.
5 5
Illustration 5.11 Connecting the LCP Cable
NOTICE
The LCP cable is not supplied. It can be ordered as an
accessory.
42
®
VLT Integrated Servo Drive ISD
Connecting the 3
1.
2.
Illustration 5.12 Connecting the 3
Disconnecting cables from ports X3, X4, and X5
1.
2.
3.
Danfoss A/S © 12/2015 All rights reserved.
®
510 System
rd
Ethernet device cable
Align the connector on the cable with the
Ethernet connector marked X3 on the servo drive.
Press the connector towards the electronic
housing of the servo drive and tighten the
threaded ring by turning it clockwise.
rd Ethernet Device Cable
Loosen the threaded ring of the connector by
turning it counterclockwise.
Disconnect the cable from the servo drive.
Protective blind caps are provided for the X3, X4,
and X5 connectors. Mount the blind caps after
removing the corresponding connector.
MG75K102