Permitted Forces; General Specifications And Environmental Conditions - Danfoss VLT Integrated Servo Drive ISD 510 System Operating Instructions Manual

Specifications

11.1.4 Permitted Forces

Illustration 11.6 Permitted Forces
Illustration 11.6 shows the maximum permitted forces on
the motor shaft.
The maximum axial and radial load while assembling the
motor and for any mechanical device connected to the
shaft, must not exceed the values shown in Table 11.4. The
shaft must be loaded slowly and in a constant manner:
Avoid pulsating loads.
®
See the VLT
Guide for bearing load curves.
NOTICE
The bearing could be permanently damaged if the
maximum permitted forces are exceeded.
11 11
Motor size
Size 1
Size 2
Table 11.4 Permitted Forces
88
®
Integrated Servo Drive ISD 510 System Design
Radial Force (Fr) in N Axial Force (Fa) in N
450 1050
900 1700
Danfoss A/S © 12/2015 All rights reserved.
®
VLT Integrated Servo Drive ISD
11.1.5 General Specifications and
Vibration test
20
Fr
Fa
Maximum relative
humidity
Ambient
temperature range
Installation
elevation
EMC standard for
emission and
immunity
Table 11.5 General Specifications and Environmental Conditions
for Servo Drive
Protection ratings
Illustration 11.7 Mounting Positions
Housing
Shaft without shaft
seal
Shaft with shaft
seal
Table 11.6 Protection Ratings
®
510 System
Environmental Conditions
Random vibration: 7.54 g (2h/axis according
to EN 60068-2-64)
Sinusoidal vibration: 0.7 g (2h/axis
according to EN 60068-2-6)
Storage/transport: 5–93% (non-condensing)
Stationary use: 15–85% (non-condensing)
5–40 °C above derating, maximum 55 °C
(24-hour average maximum 35 °C)
Transport: -25 to +70 °C
Storage: -25 to +55 °C
Maximum 1000 m above sea level
EN 61800-3
IM B5 IM V1
Mounting position of
servo drive
(according to DIN 42 950)
All positions
IM B5 & IM V1
IM V3
IM B5 & IM V1
IM V3
IM V3
IP rating
(according to
EN 60529)
IP67
IP54
IP50
IP65
IP60
MG75K102