Mechanical Installation
4
4
4
Illustration 4.6 Mounting the Decoupling Plate
Step 2: Mount the SAB in the control cabinet using the
holes drilled as described in chapter 4.4.2 Servo Access
Box (SAB) (preparation for installation).
•
Hook the SAB onto the holding screws on the
backplate of the control cabinet.
•
Tighten the holding screws.
•
Tighten the screws at the bottom of the SAB.
NOTICE
A remote mounting kit is available to mount the LCP in
the control cabinet door. See the VLT
®
Drive ISD
510 System Design Guide for further
information.
34
®
VLT
Integrated Servo Drive ISD
1
2
3
®
Integrated Servo
Danfoss A/S © 12/2015 All rights reserved.
®
510 System
MG75K102