Safety; Symbols Used In This Manual; General; Safety Instructions And Precautions - Danfoss VLT Integrated Servo Drive ISD 510 System Operating Instructions Manual

Safety

2 Safety

2.1 Symbols Used in this Manual

The following symbols are used in this manual:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.

2.2 General

The following safety instructions and precautions relate to
the ISD 510 servo system.
Read the safety instructions carefully before starting to
work in any way with the ISD 510 servo system or its
components.
Pay particular attention to the safety instructions in the
relevant sections of this manual.
WARNING
HAZARDOUS SITUATION
If the servo drive, SAB, or the bus lines are incorrectly
connected, there is a risk of death, serious injury, or
damage to the unit.
Always comply with the instructions in this manual and
national and local safety regulations.

2.3 Safety Instructions and Precautions

Compliance with the safety instructions and precautions is
necessary at all times.
•
Orderly and proper transport, storage, fitting, and
installation, as well as careful operation and
maintenance, are essential for the trouble-free
and safe operation of the ISD 510 servo system
and its components.
•
Only suitably trained and qualified personnel may
work on the ISD 510 servo system and its
components or in its vicinity. See
chapter 2.5 Qualified Personnel.
MG75K102
Operating Instructions
•
•
•
•
•
•
•
•
•
•
Danfoss A/S © 12/2015 All rights reserved.
Only use accessories and spare parts approved by
Danfoss.
Comply with the specified ambient conditions.
For further information, see chapter 11.1.5 General
Specifications and Environmental Conditions and
chapter 11.2.4 General Specifications and Environ-
mental Conditions.
The information in this manual about the use of
available components is provided solely by way
of examples of applications and suggestions.
The plant engineer or system engineer is
personally responsible for checking the suitability
of the supplied components and the information
provided in this manual for the specific
application concerned:
-
For compliance with the safety
regulations and standards relevant to
the specific application.
- For implementing the necessary
measures, changes, and extensions.
Commissioning the ISD 510 servo system or its
components is not allowed until it has been
ascertained that the machine, system, or plant in
which they are installed conforms to the statutory
provisions, safety regulations, and standards that
apply to the application in the country of use.
Operation is only allowed in compliance with the
national EMC regulations for the application
concerned.
Compliance with the limit values specified by
national regulations is the responsibility of the
producer of the plant, system, or machine.
Compliance with the specifications, connection
conditions, and installation conditions in this
manual is mandatory.
The safety regulations and safety provisions of
the country in which the equipment is used must
be observed.
To protect the user against electrical shock and to
protect the servo drive and the SAB against
overload, protective grounding is obligatory and
must be performed in accordance with local and
national regulations.
2 2
9