Nibp Alarm Setup - EDAN M3 User Manual

M3 Vital Signs Monitor User Manual NIBP Monitoring (Optional)
PRES UNIT
You may set the pressure unit to mmHg or KPa. The selected unit will present itself on the main
interface.

9.4.3 NIBP Alarm Setup

Enter SYSTEM MENU >ALARM SETUP:
Figure 9-4 Alarm Setup
Set the SYS, DIA, MAP alarm to turn on or off the alarm. Pick ON to enable prompt message
during the NIBP alarm; pick OFF to disable the alarm function, and there will be a besides
each parameter.
Set the ALM HI for the higher alarm limit, and set ALM LO for the lower alarm limit. Set the
ALM HI for the higher alarm limit, and set ALM LO for the lower alarm limit. If the measured
value is higher then ALM HI or lower than ALM LO, the monitor will give an alarm.
WARNING
In order to avoid endangering the patient's life, the user should use this function
cautiously.
The adjusting range of NIBP alarm limits is: 0 mmHg ~ 300 mmHg.
- 71 -