Temp Setup; Alarm Setup - EDAN M3 User Manual

M3 Vital Signs Monitor User Manual

4.9 TEMP Setup

Click on TEMP SETUP in SYSTEM MENU to open the following menu:
MEASURE MODE: Set this item to PREDICT or MONITOR.
MEASURE POS: Set this item to ORAL, AXILLARY or RECTA. The axillary sensor can
be used for measuring oral/axillary temperature, while the rectal sensor for measuring rectal
temperature.
NOTE:
TEMP Setup is unavailable for the monitor outfitted with the Infrared Ear Temperature
module.

4.10 Alarm Setup

Select ALARM SETUP in SYSTEM MENU to open ALARM SETUP submenu as shown
below, in which the user may turn on or off alarm or set the upper alarm limit or lower alarm
limit.
If ALM is ON, by pressing the SILENCE button on the front panel, you can silence the audible
alarm or turn off the audio system. If the ALM is OFF in this submenu, the monitor will not give
an alarm when alarm condition is active.
By configuring ALM REC, you may also enable the automatic outputting of the alarm
information in case of any physiological alarm. For more information, please refer to 5.1.3 Alarm
Setup.
Figure 4-18 TEMP Setup
- 35 -
System Menu