EDAN M3 User Manual page 80

M3 Vital Signs Monitor User Manual
MOTION noise is too large or pulse
rate is not regular.
OVER Pressure has exceeded the
PRESSURE specified upper safety limit.
SIGNAL
Excessive motion.
SATURATED
PNEUMATIC During pneumatic test, leak
LEAK is detected.
CUFF TYPE Cuff type does not comply
ERR with the patient type.
NIBP TIME Measuring time has exceeded
OUT 120s (adult) or 90s (neonatal).
Prompt message: (display in the prompt area below NIBP value):
Message
Manual measuring...
Auto measuring...
Measurement over
Calibrating...
Calibration over
Pneum testing...
Pneum test over
Resetting...
Reset failed
Low
Low
Low
Low
Low
Cause
During manual measuring mode.
During automatic measuring mode.
Measurement over
During calibrating
Calibration over
During pneumatic test
pneumatic test over
NIBP module in resetting
NIBP module reset failed
- 74 -
NIBP Monitoring (Optional)
under monitoring
motionless.
Measure again, if failure
persists, stop
measuring function of NIBP
module and
biomedical engineer
manufacturer's service staff.
Stop the patient
moving.
Check and replace
leaking parts, if required,
notify biomedical engineer or
manufacturer's service staff.
Select appropriate cuff type
Measure again or use other
measuring method.
Alarm Level
No alarm
is
using
notify
or
from
the