2. Preparing for commissioning
2.3.2 Switching on the power supply
2.3.3 Normal operating status
2-12
Warning
Uncontrolled movement of the actuators, undefined
switching statuses.
Injury to people, damage to the machine and system.
Before switching on:
Make sure that the requirements for commissioning are
met.
Check settings of the DIL switches.
During operation:
Leave switch elements of the DIL switches unchanged
during operation.
Note
Observe the switching-on instructions in the controller
manual.
After the CPX terminal is switched on, the status LEDs
(è Fig. 4/1) indicate the operating status and correct func
tion of the bus node as well as of the network communication
dependent on the configuration.
–
Bus node not configured (è Tab. 2/4)
–
Bus node configured and higher-order controller (PLC) is
in stop mode (è Tab. 2/5)
–
Bus node configured and higher-order controller (PLC) is
in the Run stop mode (è Tab. 2/6)
Information on diagnostics using the LED displays can be
found in section 4.2.
Festo CPX-FB36-EN en 1611a English