Festo CPX-FB36 Instruction Manual page 154

C. EtherNet/IP Objects of the CPX-FB36
Attr. Access Description
no.
9 Get/Set Monitoring (bit 0 ... 7)
Bit 0:
Bit 1:
Bit 2:
Bit 3:
Bit 4:
Bit 5 ... 7: reserved
1: active (presetting)
0: inactive
10 Get/Set Failsafe mode
0: Reset all outputs (presetting)
1: Hold last state (retain signal status)
2: Assume Failsafe mode
11 Get/Set Force mode
0: disabled
1: enabled
12 Get/Set System Idle mode
0: Reset all outputs (presetting)
1: Hold last state (retain signal status)
2: Assume Idle mode
13 Get/Set System start
0: System start with standard parameters (fac­
1: System start with saved parameters and sa­
Tab. C/24: Attributes of the System Object for operating mode Remote I/O (part 3)
C-22
Monitoring SCS (short circuit/over­
load sensor supply)
Monitoring SCO (short circuit/over­
load outputs)
Monitoring U
OUT
puts)
Monitoring U
VAL
ves)
Monitoring SCV (short circuit valves)
tory setting) and current CPX expansion;
external parameterisation possible
(presetting)
ved CPX expansion; parameters and CPX
expansion are saved remanently; external
parameterisation is blocked; the "Modify"
LED on the bus node illuminates
(undervoltage out­
(undervoltage val­
Type Function no.
BYTE 4401 (bit 0 ... 7)
BYTE 4402 (bit 0, 1)
BYTE 4402 (bit 2, 3)
BYTE 4402 (bit 4, 5)
BYTE 4402 (bit 6)
Festo CPX-FB36-EN en 1611a English