1. Installation
1.3.5 Setting the IP addressing
1-16
Connection with plug connector by Festo
The CPX terminal is connected to the network with plugs
NECU-M-S-D12G4-C2-ET.
The plugs are designed for network lines with cable diamet
ers of 6 ... 8 mm.
To comply with degree of protection IP65/IP67:
Use Festo plugs.
Use cover caps to seal unused connections
(è 1.4 Ensuring the degree of protection).
Alternatively the IP address for the bus node can be set via:
–
Dynamic addressing via DHCP/BOOTP (factory setting)
–
Saved addressing
–
Static addressing via DIL switches
Note
If changes are made to the network settings through the
DIL switches, the "Modify" LED (M) flashes yellow.
Restart the bus node so that the revised network set
tings can be taken over.
Festo CPX-FB36-EN en 1611a English