Festo CPX-FB36 Instruction Manual page 11

Contents and general instructions
Safety instructions
Festo CPX-FB36-EN en 1611a English
Before assembly or installation work, switch off the power
•
supply, switch off the compressed air supply, exhaust any
pneumatic components.
For the electrical power supply, only use PELV circuits in
•
accordance with IEC 60204-1/EN 60204-1.
Note the information on installation and power supply as
•
well as on potential equalisation (earthing measures) in
the CPX system description (è P.BE-CPX-SYS-...).
Observe the handling specifications for electrostatically
•
sensitive devices.
Seal unused connections with cover caps to achieve the
•
required degree of protection.
Use connection technology with the required degree of
•
protection.
Observe the specifications in the CPX system description,
•
in the descriptions of the valve terminal used as well as in
the assembly instructions of the individual components.
Observe the instructions for correctly mounting the CPX
•
terminal.
Place only a completely mounted and wired CPX terminal
•
into operation.
Only switch on the compressed air and load voltage if the
•
system has been professionally installed, configured and
parameterised.
Make sure that nobody enters the positioning range of
•
the actuators.
Switching off the compressed air or load voltage is not a suit­
able locking mechanism. Unintentional movement of actuat­
ors may occur in the event of a malfunction.
IX