Festo CPX-FB36 Instruction Manual page 37

1. Installation
Festo CPX-FB36-EN en 1611a English
Dynamic addressing via DHCP/BOOTP
Make sure there is a DHCP/BOOTP server in the network.
•
To set the dynamic addressing:
1. Switch all switch elements of the DIL switch 3 into the OFF
position (è Tab. 1/4).
2. Alternatively, activate dynamic addressing via DHCP/
BOOTP using:
– Operator unit (CPX-MMI)
– Festo Maintenance Tool (CPX-FMT) software
– "BOOTP-DHCP Server" software from Rockwell Auto­
mation
Saved network settings
The bus node offers the option of saving network settings in a
non-volatile memory unit in the bus node. DHCP/BOOTP is
thereby deactivated.
1. Switch all switch elements of the DIL switch 3 into the OFF
position (è Tab. 1/4).
2. Alternatively change the network settings via:
– Operator unit CPX-MMI
– "Festo Maintenance Tool" (CPX-FMT) program
– "BOOTP-DHCP Server" program from "Rockwell Auto­
mation"
Use this setting to activate the storage of network settings in
a non-volatile memory of the bus node.
1-17