Cable Specification - Festo CPX-FB36 Instruction Manual

1. Installation

1.3.3 Cable specification

Cable specification
Cable type
Transmission class
1)
Cable diameter
Wire cross section
3)
Connection length
1) When using plug NECU­M­S­D12G4­C2­ET
2) Required for maximum connection length between network participants
3) Corresponding to specification for EtherNet/IP networks, based on ISO/IEC 11801, ANSI/TIA/EIA-568
è
( 1.3.1 General instructions)
Tab. 1/7: Cable specification
1-14
Use sheathed Industrial Ethernet wiring of category
•
Cat 5/Cat 5e or higher (è Tab. 1/7).
The CPX bus node supports the "crossover detection" func­
tion (Auto-MDI/MDI-X). To connect the bus node to the net­
work or to a PC, this means you can choose between patch
cables or crossover cables. The circuitry of the network con­
nections X1 and X2 is adjusted automatically.
Ethernet twisted pair cable, screened
Category Cat 5/Cat 5e
6 ... 8 mm
2
0.14 ... 0.75 mm ; 22 AWG
Maximum 100 m ("end-to-end link")
Note
When mounting the CPX terminal on a moving part of a
machine:
Use network wiring with tension relief.
•
Observe corresponding stipulations of
•
IEC 60204/EN 60204.
2)
Festo CPX-FB36-EN en 1611a English