Panasonic PV-4601 A Service Manual page 65

3. Place the fixture on the Post Adjustment Plate and fit the foot to the Adjustment
Plate as shown in Fig. M11-2. (The foot of the fixture should be fully lowered until it
touches the plate.)
4. Set the fixture to zero ("0") and slowly raise the post until it just touches the foot.
When the foot touches the post, it should fit as shown in Fig. M11-3 (b).
For adjustment of P2 and P3, use a Post Adjustment Screwdriver.
2. HEIGHT ADJUSTMENT OF P5 ARM UNIT
Purpose :
To properly align the Phase and Speed Controls during the CUE/REVIEW Modes
and perform the CUE/REVIEW operations without any small additional noise in the
picture.
Symptom of Misadjustment :
1) Noticeable noise appears in the picture.
2) The tape will eventually be damaged.
*Equipment Required :
Post Adjustment Plate.......................(VFKS0010)
Reel Table Height Fixture.................(VFKS0009)
Nut Driver (5.5mm)............................Purchase Locally
*Specification.............................................0 (+0, -0.06) mm
Fig. M11-3
65