that the lower edge of the tape runs 0.25mm above the lower edge of the control
head.
If it doesnÕt, turn Black Screws (A), (B), and (C) slightly in either direction as
necessary to correct it. Turn clockwise to lower the head and counterclockwise to
raise it. When turning Screws (A), (B), and (C), they must each be turned the same
amount.
3. CONFIRMATION OF TILT OF A/C HEAD
Purpose :
To confirm that the tape runs smoothly. In particular, confirm that the tape
properly picks up the Audio Signal at the upper part of the head and the Control
Signal at the lower part of the head.
Fig. M13
68