Interlaced Image - Rutter VDR-100G3 Installation Manual

Table of Contents

Advertisement

A video source may provide a captured interlaced image like the one below. The captured image
appears vertically 2 or 3 times within the Capture window. To adjust a captured interlaced image,
complete the following steps:
Upper Image
Lower Image
1.
2.
3.
4.
VDR-100G3/G3S Installation Manual
Chapter 9: Video Module, Rev. 1.2
Figure 9-11 - Image Dimensions Ajustement confirmation
9.5.3.3
Figure 9-12 - Interlaced image
On the Configuration Page; set the Vertical Polarity to the same setting (negative
or positive) as indicated in the Auto-Detection Information Box.
Repeat for the Horizontal Polarity setting.
If either Polarity is different, change them to the setting indicated in the Auto-
Detection Information Box (for example, if the Auto-Detection indicated the Vertical
Polarity is negative ensure it is set to negative once the image has been captured.)
If the images captured are not fully visible, then the image height must be adjusted.
i. Click the Sizing tab to open the Sizing page;
ii. Click the Start button in the Dimensions section;
iii. Increase the image height to make this lower image visible;
iv. Adjust the Image Dimensions as written above; and
v. Adjust the height as necessary.

Interlaced Image

9-13
06/10/2008

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VDR-100G3 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Vdr-100g3s

Table of Contents

Save PDF