Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 163

● Operation
Specify the connection partner that establishes the VPN connection.
– disabled
– start
– wait
– on demand
– start on DI
● Keying Protocol
Specify whether IKEv2 or IKEv1 will be used.
● Remote End
Select the required partner. Only partners can be configured that have been configured
on the "Remote End" WBM page.
● Local Subnet
Enter the local subnet. Use the CIDR notation. The local network can also be a single PC
or another subset of the local network.
● Request Virtual IP
When enabled, a virtual IP address is requested from the remote station during
connection establishment.
● Timeout [sec]
Only with the "on demand" setting. Enter the interval after which the VPN connection will
be terminated. If no packets are sent during this time, the VPN connection is
automatically terminated.
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
The VPN connection is disabled.
The VPN connection is initiated by the local endpoint.
The VPN connection is established by the partner.
The VPN connection is established when necessary.
The VPN connection is established when a "Digital In" event occurs. This assumes
that the VPN tunnel is enabled when the "Digital In" occurs. You can configure the
event in "System > Events > Configuration".
Configuring with Web Based Management
4.8 "Security" menu
163