Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 155

Description
The page contains the following:
● "Service Name" input box
Enter the name of the IP service. The name must be unique.
This table contains the following columns:
● Select
Select the check box in the row to be deleted.
● Service Name
Shows the name of the IP service.
● Transport
Specify the protocol type.
– UDP
– TCP
● Source Port (Range)
Enter the source port. The rule applies specifically to the specified port.
– If the rule is intended to apply to a port range, enter the range with start port "-" end
– If the rule is intended to apply to all ports, enter "*".
● Destination Port (Range)
Enter the destination port. The rule applies specifically to the specified port.
– If the rule is intended to apply to a port range, enter the range with start port "-" end
– If the rule is intended to apply to all ports, enter "*".
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
The rule applies only to UDP frames.
The rule applies only to TCP frames.
port, for example 30 - 40.
port, for example 30 - 40.
Configuring with Web Based Management
4.8 "Security" menu
155