Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 117

● "Hardware Type" drop-down list
Specify the criterion according to which the IP address is specified.
– Ethernet MAC
– Non-HW-IP
● "Value" input box
Enter the value. The entry depends on the criterion selected in "Hardware Type".
Note
A maximum of 20 entries are possible.
The table has the following columns:
● Select
Select the check box in the row to be deleted.
● Pool ID
Shows the number of the address band.
● HW Type
Shows whether the IP address depends on the MAC address (MAC) or not (Non-HW).
● Value
Value to which the IP address is assigned.
● IP Address
Specify the IP address. The IP address must match the subnet of the address band.
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
Identification is based on the MAC address. Enter the MAC address in "Value". A
MAC address consists of six byes separated by hyphens in hexadecimal notation, e.g.
00-ab-1d-df-b4-1d.
Identification is based on a freely defined DHCP client ID. Enter the required
designation in "Value".
Configuring with Web Based Management
4.4 "System" menu
117