Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 69

Note
Note the following points about restarting a device:
• You can only restart the device with administrator privileges.
• A device should only be restarted with the buttons of this menu and not by a power cycle
on the device.
• Any modifications you have made only become active on the device after clicking the "Set
Values" button on the relevant WBM page. If the device is in "Trial Mode", configuration
modifications must be saved manually before a restart. In "Autosave mode", the last
changes are saved automatically before a restart.
Description of the displayed boxes
To restart the device, you have the following options:
● "Restart System" button
Click this button to restart the system. You must confirm the restart in a dialog box.
During a restart, the device is reinitialized, the internal firmware is reloaded, and the
device runs a self-test. The learned entries in the address table are deleted. You can
leave the browser window open while the device restarts. You then need to log in again.
● "Restore Memory Defaults and Restart" button
Click this button to restore the factory configuration settings with the exception of the
following parameters and to restart:
– IP addresses
– Subnet mask
– IP address of the default gateway
– DHCP client ID
– DHCP
– System name
– System location
– System contact
– User names and passwords
● "Restore Factory Defaults and Restart" button
Click on this button to restore the factory configuration settings. The protected defaults
are also reset.
An automatic restart is triggered.
Note
By resetting to the factory configuration settings, the device loses its configured IP
address and is
reachable again with the IP address 192.168.1.1 set in the factory.
SCALANCE S615 Web Based Management
Configuration Manual, 05/2015, C79000-G8976-C388-02
Configuring with Web Based Management
4.4 "System" menu
69