Making A Call Using Vmodem In Dial On Dtr Mode; Disconnecting A Call In Vmodem Dial On Dtr Mode - Black Box 37687 User Manual

18.In the CONNECTIONS MENU;
19.Connect the devices required to the Vmodem port on the Terminal Server using the
appropriate cable.
20.Repeat this procedure for all ports you want to configure to use Vmodem.

Making a Call using Vmodem in Dial on DTR Mode

Using Vmodem in Dial on DTR mode will cause the host IP address and remote TCP port
number to be called automatically on detection of the DTR signal being high.
1. Raising DTR (connected to DSR on the Terminal Server Vmodem port) will make a
connection to the pre-configured remote Terminal Server unit.

Disconnecting a Call in Vmodem Dial on DTR Mode

1. Dropping DTR (connected to DSR on the Terminal Server Vmodem port) will cause
disconnection, typing +++ATH will produce the same result.
Terminal Server User Guide
Configuring ports to use Vmodem
The ADMINISTRATION MENU is now displayed.
c. Press the Escape key to go back to the CONNECTIONS MENU.
a. Select a FREE connection and press the Enter key.
b. Select Commands > CLI.
Page 91
Chapter 7 Vmodem (Virtual modem)