Table of Contents
Advertisement
Configuration
The Port Setup Menu should be set up as follows for both simple dial-in connections and
PPP/SLIP connections.
The following fields are important:
Terminal Server User Guide
Configuration
Field
Description
Access
Set the Access field to Dynamic (dial-in or out) or Remote (dial-
out only).
Monitor DCD
With this flag set to Yes, the terminal server will monitor the
modem signal Data Carrier Detect (DCD) - pin 8. When the
modem hangs up, pin DCD from the modem goes low and the
terminal server port will reset.
Flow Ctrl
The modem and terminal server port should be configured to
use Hardware (RTS/CTS) flow control. This will be especially
important if you are transferring binary files.
Mode
Set this field to raw.
Page 77
Chapter 6 Dialout modem ports setup
Advertisement
Table of Contents
