Table of Contents
Advertisement
Basic configuration
To setup your communications via the command use the following instructions:
1. Enter administrative mode, password level:
local> su
Password>
2. Enter set server. This will lead you to:
ADMIN:local> set server
Type '?' at prompt to see list of valid options;
<Esc> to abort changes.
Name : ronald
Debug mode : 0
IP address : 204.17.209.18
Subnet mask : 255.255.255.0
and so on...
3. Enter reboot .
ADMIN:local> reboot
Terminal Server User Guide
Basic configuration
Page 160
Advertisement
Table of Contents
