Table of Contents
Advertisement
The modem
You will need to configure the modem using a configuration string. To do this, go to the
Remote Site Devices screen (via the Access section of the Administrative Menu). Select the
UNUSED ENTRY that corresponds to the port with the modem attached (that is, third one
down is port 3, etc.). You can set the type (for example, name) and the Modem Config to the
required configuration string (for example, ate0s0=1&w). All other fields are default.
You will now need to kill this port (from the Administration Menu or CLI) to activate the
changes and configure the modem.
The configuration string will be sent to the modem after each call, keeping the modem in
sync with Terminal Server.
Terminal Server User Guide
The modem
Page 63
Chapter 4 Setting up dial-in modem ports
Advertisement
Table of Contents
