Table of Contents
Advertisement
set
Syntax:
set <parameter> [value], etc.
Description:
The set command allows the administrator to configure any of the Terminal Server
parameters. It also allows the user to alter their own set-ups and change terminal type.
Admin level is required on most functions.
set admin
Syntax:
set admin
Description:
This function allows the user to become the administrator or admin level. The command su
can also be used.
set menu
Syntax:
set menu
Description:
This function sets the user's port into menu mode, assuming that the term type has been set.
set modem
Syntax:
set modem
Description:
This function transmits a series of modem initialisation commands to the attached modems.
A sequence of port numbers from 1 upward can be given or all to indicate all serial ports. The
modem commands are taken from the Modem Config field of the Remote site devices menu.
set term
Syntax:
set term
Description:
This function allows a user to alter their terminal type. If the term field is left blank the
Terminal Server displays a list of all the currently supported terminals (ansi, dumb, vt100,
wyse50, wyse60, tvi925, ibm3151, vt320, falco, hp700).
Terminal Server User Guide
Command descriptions
Page 165
Advertisement
Table of Contents
