Table of Contents
Advertisement
General
administration
Downloading
Terminal Server User Guide
Server configuration menu
Field
Description
Language
This field determines the language that the Terminal Server is using
such as English, French, German, etc.
Identification
This field allows the administrator to enter an identification string into
the unit and is displayed at the bottom of the menus.
Debug mode
This field is for Technical Support use only.
Field
Description
Lock
This field determines whether the Lock feature is available to all users. If
this field is set to disabled then nobody can use the Lock feature.
Password
This field defines the number of attempts a user is allowed to enter the
limit
correct password for a port. If the user exceeds this limit the Terminal
Server disables the port for 5 minutes. The Administrator can restart the
port, bypassing the timeout, by issuing a kill on that port.
CR to
This is the 'carriage return to initiate' field which designates that when
initiate
terminals are setup for initiated connections, the user must hit Enter to
establish a connection. Otherwise, any input will startup the connection
(even noise on the cable).
SNAP
This is an alternate Ethernet encoding (SubNet Access Protocol).
encoding
Field
Description
Boot host
This field should only be filled in if the Administrator wishes to
download a new firmware version. It contains the host name or IP
address of the host machine that has the Terminal Server
download image on it.
Boot file
This field contains the full path and file name of the Terminal
Server download image (including path name). Boot host
required.
Boot diagnostics
This port (if enabled) allows the TFTP download state to be
displayed on port 1 and is used for troubleshooting. Boot host
required.
Page 152
Chapter 10 The menu interface
Advertisement
Table of Contents
