Table of Contents
Advertisement
Terminal Server - User and Administration Guide
20
** Administrator **
Name
[TSERVER
IP address
[204.17.209.8
Subnet mask
[
Ethernet address [00:80:d4:00:9e:a1]
Language
[English ]
Identification
[
Lock
[Disabled]
Password limit
[5
CR to initiate
[Yes ]
SNAP encoding
[Disabled]
Boot host
[204.17.209.1
Boot file
[
Init file
[
MOTD file
[
Domain name
[
Name server
[
WINS server
[
________________________________________________________________________________
Figure 12: Server Configuration menu.
The important fields that you need to fill in are as follows:
Name:
In the example above the terminal server name
has been set to TSERVER It is a good idea for the
Terminal Server name entered here to match the
name entered in the host machine's domain
name server.
Note: For more information about domain name servers,
consult your operating system manuals.
IP Address:
This address must be set to a value that is
consistent with the network the server is on.
Having filled in the fields press the
Commands pop-up menu as shown below.
Note: The Ethernet address is factory set. This address is
uniquely assigned to the Terminal Server and MUST NOT
be changed.
SERVER CONFIGURATION
]
Debug mode
]
]
Ethernet interface [AUTO
]
]
] Boot diagnostics [Enabled ]
]
NS Port
]
key. This brings the
REMOTE-ADMIN
[0
]
]
]
]
]
]
[53
]
Advertisement
Table of Contents
