Information List - Siemens 7SC80 Manual

Addr. Parameter
712A VT Assignment
2.1.2.4

Information List

No. Information
- >Light on
- Reset LED
- DataStop
- Test mode
- Feeder gnd
- Brk OPENED
- HWTestMod
- SynchClock
1 Not configured
2 Non Existent
3 >Time Synch
5 >Reset LED
15 >Test mode
16 >DataStop
51 Device OK
52 ProtActive
55 Reset Device
56 Initial Start
67 Resume
68 Clock SyncError
69 DayLightSavTime
70 Settings Calc.
71 Settings Check
72 Level-2 change
73 Local change
110 Event Lost
113 Flag Lost
125 Chatter ON
140 Error Sum Alarm
160 Alarm Sum Event
177 Fail Battery
178 I/O-Board error
181 Error A/D-conv.
191 Error Offset
193 Alarm NO calibr
194 Error neutralCT
301 Pow.Sys.Flt.
302 Fault Event
303 sens Gnd flt
320 Warn Mem. Data
SIPROTEC Compact, 7SC80, Manual
E50417-G1140-C486-A8, Edition 07.2017
Setting Options
6xPT
4xPT
Type of Comments
Informa-
tion
SP >Back Light on
IntSP Reset LED
IntSP Stop data transmission
IntSP Test mode
IntSP Feeder GROUNDED
IntSP Breaker OPENED
IntSP Hardware Test Mode
IntSP_Ev Clock Synchronization
SP No Function configured
SP Function Not Available
SP_Ev >Synchronize Internal Real Time Clock
SP >Reset LED
SP >Test mode
SP >Stop data transmission
OUT Device is Operational and Protecting
IntSP At Least 1 Protection Funct. is Active
OUT Reset Device
OUT Initial Start of Device
OUT Resume
OUT Clock Synchronization Error
OUT Daylight Saving Time
OUT Setting calculation is running
OUT Settings Check
OUT Level-2 change
OUT Local setting change
OUT_Ev Event lost
OUT Flag Lost
OUT Chatter ON
OUT Error with a summary alarm
OUT Alarm Summary Event
OUT Failure: Battery empty
OUT I/O-Board Error
OUT Error: A/D converter
OUT Error: Offset
OUT Alarm: NO calibration data available
OUT Error: Neutral CT different from MLFB
OUT Power System fault
OUT Fault Event
OUT sensitive Ground fault
OUT Warn: Limit of Memory Data exceeded
Default Setting Comments
6xPT VT Assignment
Functions
2.1 General
47