Leica FlexLine plus User Manual page 67

Access
Stakeout Settings
FlexLine plus, Programs
1. Select Programs from the Main Menu.
2. Select Stakeout from the Programs Menu.
3. Complete program pre-settings. Refer to "6 Programs - Getting Started".
Field Description

Pre-/Suffix
Prefix
Suffix
Off

Identifier
The identifier can be up to four characters and is added at the start,
or end, of a point number of a point to be staked.
Stakeout Beep On
Off
Filter Off
Nearest
Radius
PtId Range
The point to which the radius is applied.
Center Point
The radius of the circle within which the points are shown.
Radius
The first point to be displayed.
From
To The last point to be displayed.
Only used for the Stakeout program.
Adds the character entered for Identifier in front of
the original point number of the point to be staked.
Adds the character entered for Identifier at the end
of the original point number of the point to be
staked.
The staked point is stored with the same point
number as the point to be staked.
Only used for the Stakeout program.
The instrument beeps when the distance from the
current position to the point to be staked is
The closer the prism is to the point to be staked the
faster the beeps will be.
Beep is deactivated.
No filter is active
Searches the job for points close to the current posi-
tion. The points are selected as the points to be
staked. After staking and storing the first nearest
point, the next nearest point is suggested for
staking out.
The program algorithm sorts the points according to
the minimum walking distance in all directions to
each point.
Shows points within the defined radius from a
particular point. The radius is the horizontal
distance.
Shows points with point IDs between the entered
start and end ID.
0.5 m.
67