Leica FlexLine plus User Manual page 157

Check and adjust
step-by-step
Messages
FlexLine plus, Check & Adjust
1. Level the instrument with the electronic level. Refer to "4 Operation"- "Level up
with the electronic level step-by-step".
2.
± 5°
TSOX_064
3. Press Store to measure to the target point.
4.
180°
180°

TSOX_065
For checking the horizontal aim, the difference in Hz and V are displayed.
5. Press Store to measure to the target point.

The old and new calculated values are displayed.
6. Either:
• Press More to measure another set to the same target point. The final
adjustment values will be the calculated average from all the measure-
ments.
• Press Cont to save the new adjustment data, or
• Press ESC to exit without saving the new adjustment data.
The following are important messages or warnings that may appear.
Messages
V-Angle is not suita-
blefor adjustment or
wrong face!
Out of Tolerance!
Previous values
retained!
Hz-Angle is not suit-
able for adjustment!
Timelimit
exceeded!Please
repeat Adjustment!
Aim at a point approximately 100 m from the
instrument which is within 5° of the hori-
zontal.
Change face and aim at the target point again
Description
The vertical angle deviates from the required horizontal /
line-of-sight, or in face II the vertical angle deviates by more
than 5° from the target point. Aim at the target point with
an accuracy of min. 5° or, when adjusting the tilt axis, 27°
above or beneath the horizontal plane. Confirmation of the
message required.
Computed values out of tolerance. The previous values are
retained and measurements should be repeated. Confirma-
tion of the message required.
Horizontal angle in face II deviates by more than 5° from the
target point. Aim on the target point with an accuracy of
min. 5°. Confirmation of the message required.
Time difference between measurements for results storage
exceeds 15 minutes. Repeat the process. Confirmation of
the message required.
157