Leica FlexLine plus User Manual page 2

Introduction
Purchase
Product identifica-
tion
Trademarks
Validity of this
manual
WARNING
FlexLine plus, Introduction
Congratulations on the purchase of a FlexLine plus instrument.
This manual contains important safety directions as well as instructions for setting up
the product and operating it. Refer to "1 Safety Directions" for further information.
Read carefully through the User Manual before you switch on the product.
The model and serial number of your product are indicated on the type plate.
Always refer to this information when you need to contact your agency or Leica
Geosystems authorised service workshop.
• Windows is a registered trademark of Microsoft Corporation.
®
Bluetooth
• is a registered trademark of Bluetooth SIG, Inc.
All other trademarks are the property of their respective owners.
Description
General This manual applies to TS02 plus, TS06 plus, and TS09 plus instru-
ments. Where there are differences between the various instru-
ments they are clearly described.
For the Tunnel application, refer to the separate manual "Leica
FlexLine plus Tunnel Application".
Telescope • Measuring with Prism mode: When measuring distances to a
reflector with Electronic Distance Measurement (EDM) mode
"Prism", the telescope uses a wide visible red laser beam, which
emerges coaxially from the telescope's objective.
• Measuring with Non-Prism modes: Instruments that are
equipped with a reflectorless EDM additionally offer the EDM
mode "Non-Prism". When meauring distances with this EDM
mode, the telescope uses a narrow visible red laser beam, which
emerges coaxially from the telescope's objective.
TSOX_135
Do NOT remove the battery during operation of the instrument, or during the shut-
down procedure.
This can result in a file system error and data loss!
Always switch off the instrument by pressing the On/Off key, and wait until the
instrument has shutdown completely before removing the battery.
2