Trane S*HF*20-75 Troubleshooting Manual page 86

SETPOINT Menu
Default Occupied Zone Temp Setpoints
Cool: 74°F
"Cool" setpoint shown for CVZT units. "Heat" setpoint shown for
CVZT w/heat installed, or VV/CVDA units with DWU or MWU
enabled.
• Press Next/Previous keys to navigate.
Derived Zone Setpoint Deadband:
Used When Only One Setpoint is Available
• Press Next/Previous keys to navigate.
Default Unoccupied Zone Temp Setpoints
Cool: 85°F Heat: 60°F Morn Warmup: 72°F
Note: Minimum difference of 2ºF maintained between Heating &
Cooling Setpoints. Morning warmup cannot be lower than Heating
Setpoints.
"Heat" and "Morn Warmup" shown for units w/heat installed.
"Morn Warmup" shown if MWU is enabled.
• Press Next/Previous keys to navigate.
Dflt Rapid Restart Critical Temp:
Return temperature relative to this setpoint determines target DX
stage during a Rapid Restart event.
• Press Next/Previous keys to navigate.
HUMIDITY CONTROL SETPOINT SUBMENU SCREENS
Humidity Control Setpoint Submenu
Press ENTER to Review or Adjust
• Press the Next key to skip this Submenu.
Dehumidify if Space Humidity Above
Occ Dehumidification Setpoint:
• Press Next/Previous keys to navigate.
86
Heat: 71°F
Used With: CVZT or VVZT Units, or VV/
CVDA Units w/DWU or MWU Enabled
Factory Presets:
Cool: 74ºF
Heat: 71ºF
Possible Values:
Heat: 50 to 90ºF
Used With: CVZT or VVZT Units w/Zone
2.0°F
Sensor Supporting Only One Setpoint
Factory Preset: 4.0ºF
Possible Values: 2.0 to 10.0ºF
Used With: All Units
Factory Presets:
Cool: 85ºF
Heat: 60ºF
MWU: 72ºF
Possible Values:
Cool: 52 to 90ºF
Heat: 50 to 88ºF
MWU: 50 to 90ºF
Used With: All IntelliPak Units w/Rapid
90°F
Restart Installed
Factory Preset: 90ºF
Possible Values: 75, 80, 85, 90, 95 ºF
Used With: Units w/Dehumidification or
Humidification Option
Used With: Units w/Dehumidification
Option
60%
Factory Preset: 60 %
Possible Values: 40 to 65 %
RT-SVP07B-EN