Trane S*HF*20-75 Troubleshooting Manual page 100

CONFIGURATION Menu
Configuration - Model Num Digit 21 or 31
Ventilation Ctrl
Notes:
1. A VCM module will be required installed if: "Fresh Air
Measurement (VCM) w/DCV OPTION" is selected, or
2. "OA Damper Min Pos (VCM) w/DCV Option" is selected and DCV
Control in the setup menu is set to ENABLED.
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 21 or 23
Comparative Enthalpy:
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit
Final Filters:
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit
Energy Recovery:
Note: "Energy Recovery" is not permitted to be installed here if
"Return Fan..." option above is set to INSTALLED.
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit
Condenser Type:
Note: This selection must match the physical unit configuration or
improper operation and unit damage may occur. "Sump HT" refers
to the Sump Heater installation.
• Press Next/Previous keys to navigate.
100
(VCM) CONFIG REQ'D
INSTALLED
INSTALLED
NOT INSTALLED
Air-Cooled
Used With: All Units
Possible Values:
Vent. Ctrl (VCM) NOT INSTALLED
Fresh Air Meas. (VCM)w/DCV OPTION
OA Damp Min Pos (VCM)w/DCV
OPTION
Used With: All Units
Possible Values:
NOT INSTALLED
INSTALLED
Used With: IPak II Units
24
Possible Values:
NOT INSTALLED
INSTALLED
Used With: IPak II Units
25
Possible Values:
NOT INSTALLED
INSTALLED W/O PREHEAT
INSTALLED W/ PREHEAT
Used With: IPak II Units
27
Possible Values:
AIR-COOLED
WATER-COOLED W/O SUMP HT
WATER-COOLED WITH SUMP HT
RT-SVP07B-EN