Trane S*HF*20-75 Troubleshooting Manual page 102

CONFIGURATION Menu
Configuration - Model Num Digit 21 or 34
Rapid Restart:
Note: Rapid Restart functionality can be inhibited by setting this
parameter to NOT INSTALLED. If set to NOT INSTALLED the unit
will perform DX staging at restart.
• The following screens will be shown if there is a GBAS(5VDC)
Rapid Restart hardware configuration failure. Otherwise press
Next/Previous keys to navigate.
GBAS Configuration Hardware Has Failed
Press Enter to Reset, CANCEL to Ignore
Note: This screen is shown if the unit was configured for Rapid
Restart and the hardware configuration input on the GBAS(5VDC)
has failed or has been changed.
• Press the ENTER key to accept, and review the following screen.
Check GBAS Config Hardware, Cycle Power
RETURN HERE TO CONFIRM CONFIGURATION
Note: This screen instructs the user to:
1. Turn OFF the power to the unit.
2. Inspect the GBAS(5VDC) hardware configuration input.
3. Restore the power to the Unit.
4. Return to this configuration screen and verify entry.
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 34 or 31
Ventilation Override (VOM)
• Press Next/Previous keys to navigate.
Unit Model Number
Note: The screen is only displayed on units with the original RTM
modules installed at the factory. If the RTM is replaced in the field
it will no longer be displayed.
• Press Next/Previous keys to navigate.
102
Used With: Units with GBAS(5VDC)
Hardware Configuration - Rapid Restart
INSTALLED
Possible Values:
INSTALLED
NOT INSTALLED
Used With: All Units
Possible Values:
INSTALLED
NOT INSTALLED
INSTALLED
Used With: All Units
Possible Values:
Model Number information as reflected
on the unit nameplate.
RT-SVP07B-EN