Lower Sensor Receiver Assembly - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Standard Feeder (WF9S) Parts Removal
5.23 Lower
Sensor
(Receiver)
Assembly
on Standard
Feeder
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Disengage the feeder assembly from the printer and remove the deck
and rear cover (see section 5.22).
2. Remove "H" block by lifting up tab and sliding assembly up and out.
3. Cut the wire tie holding the sensor cables.
4. Unfasten the screw securing the feeder lower sensor assembly and re-
move the sensor.
5. Pull the sensor harness through the hole in the bottom of the feeder as-
sembly.
6. Reinstall in reverse order.
NOTE: Replacing the feeder lower sensor assembly will require an ad-
justment. Refer to section 6.3 Feeder Sensor Test and Calibration for
more information.
Removal and Replacement • 5
"H" Block
Wire Tie
Feeder Lower
Sensor Assembly
with Screw
5-41