Feed Belts And Rollers - Pitney Bowes DA80F Service Manual

5 • Removal and Replacement
DA95F (WF96) - Standard Feeder (WF9S) Parts Removal
5.26 Feed
Belts and
Rollers on
Standard
Feeder
✍
If pulleys were
TIP:
removed from the
shafts, you need to
perform the gap ad-
justment procedure
on the next page.
5-44
1. Disengage the feeder assembly from the printer and remove the side
guides, deck, and rear cover (see section 5.22).
2. Located the feeder assembly and the handle of the swing arm near the
floor of the chassis (see figures below). Insert a long screwdriver or a
long sturdy metal bar behind the handle. Pull the screwdriver against the
belt and feed pulley to use as a fulcrum. This will release the tension on
the belt created by the extension spring.
3. Remove the 3 mm belt from around the other feed pulley and idler pul-
leys. Release the swing arm to finish removing the belt.
3mm
Belt
Extension
Spring
4. Pull the belt drive upper or lower shaft assembly from the printer. The
feed belts and a bearing will come out with the shaft assemblies. Re-
move these parts from the printer.
5. The tires and feed belts may be removed by pulling them from the hubs.
Tires
3mm Belt
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Feeder Assembly
in Standard Feeder
3mm Belt
Extension Spring
Swing Arm Handle
Fulcrum
Screwdriver
Handle
Handle (in
up position)
Extension
Spring
3mm Belt
Tire
Hub
3mm Belt