Idler Roller Support ("Module A") Assembly; Idler Roller Support ("Module B") Assembly - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Printer Parts Removal
5.34 Idler
Roller Support
("Module A")
Assembly
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Remove the front cover assembly (see section 5.29) and rear cover (see
section 5.30).
2. Unfasten the four screws (two on either side, see figure below) and re-
move the idler roller support assembly.
Idler Roller for "Module A" Removed
3. Unfasten the two screws (one on either side) holding each idler roller to
its idler roller arm and remove idler roller.
4. Reinstall in reverse order.
Removal and Replacement • 5
Two Screws
(obscured in
figure)
Idler Roller for
"Module A"
Two Screws
(obscured in
figure)
Two Screws for Each Idler
Roller (8 screws total)
5-57