Appendix C - Schematics; Main Processor Board For Both Printers; Da80F (Wf81) Printer Block Diagram; Da95F (Wf96) Printer Block Diagram - Pitney Bowes DA80F Service Manual

List of
Schematics
✍
TIP: A Pitney Bowes
W98x series stacker
connects to either
printer using the 4-pin
connector at the end
of the printer, while a

third-party conveyor

is connected to the
DA80F using the RJ-11
accessory port by the
power switch.
✍
TIP: The standard
feeder (WF9S) for
a WF96 printer is
connected to the
8-pin connector
on the side of the
DA95F printer,
while a non-stan-
dard feeder is con-
nected to the RJ-11
accessory port by
the power switch.
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Appendix C • Schematics
• Accessory Ports for External Devices ......................................... C-1
• Main Processor Board for Both Printers .......................................C-2
• DA80F (WF81) Printer Block Diagram .........................................C-3
• DA95F (WF96) Printer Block Diagram .........................................C-4
Accessory RJ-11 Port on WF81/DA80F for Third-Party Conveyor
The RJ-11 Accessory Port by the power switch on the printer (J12 on the
Main Controller Board) allows you to connect a third-party conveyor to the
DA80F printer. See Conveyor Setup in section A.4 for the LCD Menu control
panel settings needed to connect an external conveyor.
Accessory Port on WF96/DA95F for External High Speed Feeder
The RJ-11 accessory port by the power switch on the printer (J21 on the
Main Controller Board) allows you to connect an external feeder to the
DA95F printer. See Feeder Setup in section A.4 for the LCD Menu control
panel settings needed to connect an external feeder.
C-1