Entry Idler Roller Arm - Pitney Bowes DA80F Service Manual

5 • Removal and Replacement
DA80F (WF81) Parts Removal
5.16 Entry Idler
Roller Arm
5-28
1. Remove the rear cover (see section 5.2) and print head assembly (see
section 5.15).
2. Unfasten two screws securing the front top cover and remove the cover.
3. Remove two springs, one for each entry idler roller (see figures below).
Entry Idler
Entry Idler Roller
Roller Shaft
Springs (Circled)
4. [Only if idler roller shaft is to be replaced] - Unfasten screw (circled in fig-
ures below) on either end of idler roller shaft and remove shaft.
5. Remove the e-ring from the shaft and entry idler roller from the shaft.
NOTE: The nylon washer between the roller and the entry idler arm as-
sembly may fall off when the roller is removed.
Entry Idler Rollers
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Front
Top
Cover
Screws
for Top
Cover
(Circled)
Removing Entry Idler Roller Spring
Screws
for Idler
Roller
Shaft
(Circled)
E-ring