Feed Roller Pulley And Feed Roller Assembly - Pitney Bowes DA80F Service Manual

Hide thumbs Also See for DA80F:
Table of Contents

Advertisement

5 • Removal and Replacement
DA80F (WF81) Parts Removal
5.11 Feed
Roller Pulley
and Feed
Roller
Assembly
5-14
1. Remove the rear cover (see section 5.2), the main processor board (see
section 5.3), front bottom cover (see section 5.8), and transport timing
belt (see section 5.9).
2. Raise the H-block assemblies by lifting the lever assemblies up and lock
into place.
3. On the front side, unfasten the two screws each with a split lock washer
and a bearing retainer that secure the feed rollers flanged bearing on the
front plate assembly.
4. Loosen top screw and unfasten bottom screw on brake assembly. Swing
brake assembly to the side. Pop bearings out and remove break assembly.
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Lever
Assemblies
Lifted Up
"H" Block
Assemblies
Feed Roller (on top, not shown)
Two Screws Holding
Bearing, Circled in White
Bearing/Brake Assembly
Top Screw (loosen)
Brake Assembly
Bottom Screw (remove)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Da95fWf81Wf96

Table of Contents