Belt Drive Assembly - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Printer Parts Removal
5.37 Belt Drive
Assembly
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Disengage the feeder assembly from the printer (see section 5.22).
2. Remove all covers, shafts, support frames, print heads, etc. from printer
(see sections 5.28 to 5.36).
3. Unfasten the six screws (three on either side, see figure below) and re-
move the exit frame support (procedure not documented until now).
Exit Frame
Support
Three Screws
(one side only)
4. Unplug from the main board the feeder motor/encoder/feeder sensors
(J15) and unplug shaft encoder cable (J34). Push the cables through the
openings in the base assembly.
5. Unfasten eight screws attaching the belt drive assembly to the base as-
sembly.
6. Holding the front of the assembly against the base assembly, grasp the
far belt and pivot the assembly about the front edge. Do it slowly so as
not to snag any of the cable assemblies. Clip the tie wrap at bottom of
base holding cables.
Removal and Replacement • 5
Screws
Screws
5-67